Compacted dispersal is not hard enough to move the crowd several times to disperse the back edge. Oncology is open to suggestions. All those extra bumps and pits to eliminate by using a shovel. Part B – Table. Some mistakenly call a table space from the edge Jumping before the landing. But in principle, the table is flat or nearly flat portion that serves to set the kicker, that is directly of the ramp.
How to make himself a kicker (Part-E) to tell a little bit later. Very important point is that place where it is put, it is necessary that before the kicker was a flat area, because if you put it on a slope, on arrival very strongly to be beaten on his legs, and inertia is lost. It is very important and not should it be ignored. Part D – Transit is the place from the edge of kicker before landing. The dimensions of transit (ie flight) may vary depending on terrain and on your level of skiing. Typically, about sizes can be seen jumping on the size of a modern profristail snowboarding risen to very serious dimensions, 30 meters transits are no rarity. That is, you can fly all the 45, if in the end pulnut touchdown In my opinion, academic springboard enough to properly twist, should be flown (ie transit) somewhere from 4 to 7 meters. Part C – landing. Touchdown should be quite a serious bias to repay the vertical speed of the rider, and of sufficient length, because if you fly over the landing and bang on ploskach, the consequences are very serious.